Zippers
5 min read•Nov 16, 2026

How to Sew a Zipper into a Bag

Andrea Endroes
Four illustrated steps for sewing a zipper into the top edge of a bag: mark center and stops, stitch the zipper, add the lining, topstitch the lining
Key Takeaways
  • Mark the Center: Match the center of the zipper to the center mark of the bag on both sides.
  • Stitch Mark to Mark: Mark where stitching starts and stops, allowing for the side seam allowance.
  • Add the Lining: Lay the lining right sides together over the zipper and stitch the same seam.
  • Topstitch Toward the Lining: Press the seam allowance toward the lining and topstitch close to the edge.

To sew a zipper into a bag, mark the center of the top edge and of the zipper, mark where the stitching starts and stops so the side seams stay free, and stitch the zipper to the top edge from mark to mark. Then lay the lining right sides together over it and stitch again. Finally press the seam allowance toward the lining and topstitch close to the edge, so the lining stays inside when the bag is open.

Zipper Installation at a Glance

StepWhat you doWhy it matters
1Mark the center on the bag and on both sides of the zipperThe zipper sits straight and even
2Mark start and stop points, allowing for the side seamsThe side seams can be sewn later without catching the zipper
3Pin and stitch the zipper to the top edge, mark to markA clean, secure closure
4Lay the lining right sides together and stitchThe zipper tape is hidden between outer fabric and lining
5Turn the seam allowance toward the lining and topstitchThe lining does not spill out when the zipper is open

A zipper along the top edge gives a bag a secure closure and a neat, professional finish. The method in the course uses a zipper with an end piece, which should always be a little longer than the width of the bag.

What You Need

  • A zipper with an end piece, a little longer than the bag is wide

  • The outer bag pieces and the lining pieces, with a small snipped center mark at the top edge

  • Chalk and a measuring tape

  • Pins or clips

  • A sewing machine; sew slowly over the zipper

Step by Step

Mark the Center and the Stop Points

Find the center pinch at the top edge of the bag and mark the center on the zipper. Close the zipper and transfer that mark to the other side, so you know exactly where the second bag piece goes. Then mark the side seam allowance on the bag and mark on the zipper where the stitching will start and stop. Stitching stops short of the side edges so the side seams stay free.

Stitch the Zipper to the Top Edge

Pin the zipper along the top edge, center mark to center mark, with the zipper edge against the bag edge. Stitch from mark to mark, backstitching at both ends. Repeat on the second side of the bag. When you close the zipper, the two center marks should meet.

Add the Lining

Lay the lining and the outer fabric right sides together with the zipper in between, center mark on center mark, and clip. At the start, fold the beginning of the zipper so it runs into the bag; at the end, let the zipper run round into the bag in a gentle curve. Stitch the seam along the edge of the zipper, slowly over the teeth.

Cross-section diagram of a bag top edge with the zipper between outer fabric and lining, the seam allowance turned toward the lining and topstitched
The seam allowance goes toward the lining and is topstitched close to the edge

Topstitch the Lining

Lay the whole seam allowance toward the lining and topstitch close to the edge. This keeps the lining from spilling out of the top of the bag when you open the zipper. Do the same on the other side.

Tip from the lesson

With an endless zipper that is not secured at the front, never pull the slider off the end while you work. If it happens, you have to open the end piece, re-thread the slider and make a new end piece.

Common Mistakes

Inaccurate marking

Uneven measuring or marking gives a zipper that sits crooked or misaligned along the top edge.

Bulky or loose zipper ends

Zipper ends that are not secured or do not lie flat get in the way of a smooth closure.

Lining too close to the zipper

A lining sewn too close to the zipper track can jam the slider.

A well-finished top edge is part of a good bag interior. For more ideas, read what makes the perfect bag interior.

See It on Video

Sewing a zipper into the top edge of a bag with its lining is shown step by step in close-up video in the Bag Sewing Fundamentals course. See the bag making courses.

Frequently Asked Questions

How do I keep the zipper straight on the bag?

Mark the center on the bag and on both sides of the zipper, and pin center mark to center mark before stitching.

Where do I start and stop stitching the zipper?

Mark the side seam allowance and stop the stitching short of the side edges, from mark to mark, so the side seams can be sewn later.

How do I stop the lining from showing when the bag is open?

Lay the seam allowance toward the lining and topstitch close to the edge. That keeps the lining inside the bag.

Why does my zipper slider jam?

The lining may be sewn too close to the zipper track. Keep the stitching along the edge of the zipper tape, away from the teeth.

Bag Sewing Fundamentals Course
Recommended Course

Bag Sewing Fundamentals Course

The comprehensive foundation to sew boutique-grade structured bags on your domestic machine

See the Course